The 10 Best Used Electric Tank Hot Water Heaters 50 Gallons

Product Description

This Smart Technology electric tankless water heater is configured as a “whole home” model for climates where incoming water temperature is 67°F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67°F and an output setting of 105°F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. All tankless water heaters are sized based on flow rate and temperature rise, and there is a direct relationship between the two. So if used in a cold area requiring a high temperature rise, it will be more limited in the amount of fixtures (gallons per minute) it can heat at one time compared to a warmer climate. When sized properly this water heater will provide endless hot water and only consume the energy needed, giving the user complete control. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The ECO 11 requires a minimum 125 amp electrical panel for installation with (1) 60 amp double pole breaker connected to (1) set of #6 awg wire. Plumbing connections are 1/2″ compression fitting with the option of 1/2″ NPT adapter included. For additional assistance please feel free to contact our support center at 877-474-6473.

NOTE : 11Kw at 220 is equal to 13kw at 240.

From the Manufacturer

This Smart Technology electric tankless water heater is configured for climates where incoming water temperature is 67 Degree F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67 Degree F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

Product Description

606 series. 1650/120V. UL listed. No dip tube since the bottom inlet eliminates need for it. 1″ foam insulation/16.00 R-value. Factory installed T&P valve. Meets NAECA codes. Glass lined tank. Inlet and outlet connections on side for easier installation in tight spaces. Warranty: 6 year tank/parts.

From the Manufacturer

Series 606 electrics provide up to 4,500 watts/hr. input — plenty for all your hot water needs.

Feature:
– No tank needed
– Instant water heating
– Overheat safety device
– Heat resistant metal body
– Low water pressure startup function
– 2 D batteries automatic IC ignition system
– Discharge Ways: Flue automatic gas discharge
– Easy installation (installation video can be sent if need)
– Comes with the shower head and pipe (Not included Exhaust Pipe)
– Perfect For House or apartment,Pool side hot shower rinse offs,Cabins,Campers,RVs,Concession & Catering Trailers,Mobile homes,Animal Washing,Boats and more.

Specification:
– Heat Load: 12KW
– Gross weight:5KG (11.0 lb)
– Rate Gas pressure:2800Pa (about 0.4 PSI)
– Applicable water pressure:0.015Mpa pressure starting
– (25 degrees) warm water producing rate:6L/min (6kg/min)
– Packing Size:335 x 170 x 520 mm (13.2 x 6.7x 20.5 inch)
– Cold water pipeline:Short pipeline equipped or G thread 1/2 steel tube
– Warm water pipeline:Long pipeline equipped or G thread 1/2 steel tube
– Gas pipeline (internal diameter):F 9.5mm(1/2 inch) oil-proof rubber tube ( not included)

Package Included:
– 1x Gas Water Heater (Not included exhaust pipe)
– 1x Shower Kit
– 1x English User Manual

Notice: Not included Exhaust Pipe
Pipe thread for gas and water valves are not American, you may need to buy some NPT adapters

Professional classic® tankless electric water heaters offer continuous hot water quick and on demand for single point-of-use or multiple applications

Professional classic® tankless electric water heaters offer continuous hot water quick and on demand for single point-of-use or multiple applications

The Stiebel Eltron Tempra 24 Plus Tankless Water Heater features exclusive Advanced Flow Control™ German patented technology invented by Stiebel Eltron to automatically maintain water temperature for constant comfort. It’ll reduce flow slightly if hot water demand exceeds capacity to ensure that hot showers will never be interrupted. Tempra 24 Plus will typically use 15-20% less energy compared to conventional electric tank water heaters. Although, it’s possible to save significantly more energy depending on personal home usage habits. The difference is that conventional tank water heaters continually store hot water, and as a result, lose 15%-20% of the total energy consumed to the environment around them. This is called standby heat loss. Tank water heaters that use gas or oil are even less efficient, because they also lose heat through their vents to the outdoors. Our tankless water heaters do not need venting, and will not store hot water, waiting for you to use it. They operate on-demand to provide continuous and endless hot water when you need it, and not waste energy when you don’t. CERTIFICATIONS INCLUDE – ANSI/UL Std. 499, CSA Std. C22.2 No. 88, ISO 9001, WQA tested & certified against NSF/ANSI 372 for lead free compliance. TECHNICAL SPECIFICATIONS – Single Phase 50/60 Hz; Voltage: 240 V/208 V; Wattage: 24 KW/18 KW; Min. recommended household electric service 150 A; Amperage draw: 2 x 50 A 2 x 44 A; Number and min. recommended size of circuit breakers: 2 x 50 A (DP); Number of runs and min. recommended wire size (copper): 2 x 6/2 AWG; Max. temperature rises: 92 F/82 F at 1.50 GPM, 73 F/54 F at 2.25 GPM, 54 F/41 F at 3.00 GPM, 37 F/27 F at 4.50 GPM; Min. water flow to activate unit: 0.50 GPM/1.9l/min; Weight: 16.1 lb/7.3 kg; Nominal water volume: 0.26 gal/1l; Max. inlet water temperature: 131 F/55 C; Working pressure: 150 PSI/10 BAR; Tested to pressure: 300 PSI / 20 BAR; Water connections: 3/4″ NPT.

Product description

When compared to gas type tankless water heaters, Stiebel Eltron Tempra 20 Plus cost less and is less expensive to install, since it does not require venting parts. While gas type tankless water heaters with outside venting may have a 5-20% efficiency reduction (due to heat loss from gases escaping through the vent), Stiebel Eltron Tempra 20 Plus is designed to be virtually 100% efficient. Multiple heating elements inside the Tempra 20 Plus models activate as the water demand increases, thus providing maximum efficiency and complete comfort. The Advanced Flow Control system, available in Plus models only, monitors and adjusts the water flow to assure a constant temperature output. Specs: Flow Rate: 0.58 – 4.5 GPM; Maximum Operating Pressure: 150 PSI; Hot / Cold inlet connections: 3/4″ male threaded (Male NPT); Dimensions (Width x Height x Depth): 16 5/8″ x 14 1/2″ x 4 5/8″; Weight: 15.4 lbs; Voltage: 208V/240V; Amperage: 70 Amps at 208V / 80 Amps at 240V; Phase: 2 x single; Wattage: 14.4 kW at 208V / 19.2 kW at 240V; Min. Circuit Breaker Size Required: 2 x 50 Amps; Recommended Wire Size: 2 x 8 AWG copper;

From the Manufacturer

The Tempra® Plus is the most technologically advanced tankless water heater available on the market today. Advanced Flow Control is exclusive to the Tempra® Plus and ensures a constant temperature output no matter how great the hot water demand is. Advanced Flow Control technology works by automatically adjusting the flow of water to eliminate unpleasant temperature fluctuation. What that means to you is a consistently satisfying experience every time, all the time !

The Eccotemp i12 Liquid Propane 3 GPM Tankless Water Heater has a new revolutionary design, making it unlike any other tankless water heater on the market today. The Eccotemp i12-LP is perfect for vacation cabins, cottages, and smaller homes. This model features sleek black tempered glass paneling, fully automatic temperature controls for precision, and a touch screen with an LED temperature display that shows output temperature and GPM flow. The i12-LP is also equipped with child locking technology. The Eccotemp i12-LP is a liquid propane powered, indoor model designed for small to medium hot water production where you need more than one hot water application at the same time. This model also offers a 35-40 degree Fahrenheit temperature rise when operating at a flow rate of 4 GPM and a 77-degree Fahrenheit temperature rise at 1.5 GPM. This bundle comes with a horizontal stainless steel vent kit, ready to install and with its 110-volt UL listed power cord powering the internal exhaust fan and digital display. The i12 only pulls about 2 watts while idle and 1.07 Amps during operation, making it an ideal energy efficient appliance.

Product Features

• Sleek, modern design with black tempered glass front panel
• Equipped with child locking technology
• Pulls about 2 watts idle and 1.07 Amps during operation
• Fully automatic temperature controls
• Horizontal Stainless Steel vent kit included
• Perfect for vacation cabins, cottages, and smaller homes
• Hot water capacity range: 0.6 – 4.8 GPM; Maximum / Minimum gas rate: 25,000 – 80,000 BTUs

What’s in the box?

• 1 x 2 1/2″ 90 degree Elbow with Backflow Preventer
• 1 x Wall Thimble
• 1 x 2 1/2″ x 20″ Termination Pipe
• 1 x Instruction Manual
• 1 x 110 volt UL listed power cord

The heat electric tank less water heater S-14 model has the capacity of heating 3 gpm which is the equivalent to 2 showers (at 1.5 gpm each), or 1 shower and 3 sinks (at 0.50 gpm each) simultaneously, or any combination which equals to 3.0 gpm. The S-14 can handle these applications in the warmer climates of the us which are Florida, Georgia, Louisiana, Texas, Arizona, California, Alabama, and Mississippi. Anything north of these States the S-14 model can be used for point of use, or 2 to 3 applications at a time equaling 3 gpm. A good rule of thumb is if you live in the southern States mentioned here the S-14 can power a 1 to 3 bedroom 1 to 2 bathroom home, including dishwasher and clothes washer, please keep in mind that tank less water heaters are designed to heat incoming water at a maximum output temperature based on simultaneous use and inlet water temperatures. So if your demand for hot water decreases your output water temperatures will increase, as well as if you live in the colder States this S-14 will heat less volume of water, this will cause the S-14 to be used in point of use applications in the colder climates.

Conclusion

By our suggestions above, we hope that you can found used electric tank hot water heaters 50 gallons for you.Please don’t forget to share your experience by comment in this post. Thank you!